| Section |
Topic |
Details |
 |
 |
Replies |
Last |
|
Volvo:40,41,42,43,44 Series -
|
41p Oil Pressure |
VIEW/REPLY |
|
|
1
|
Fri Nov 20 09 3:51 PM |
Yesterday
12:11 AM |
 |
Cat-man
What would be the ideal oil pressure on these motors that are warmed up, under a load and the outside air temp 45f degrees?
Thanks
cat-man |
|
1 Response....
|
|
Yesterday
03:51 PM |
#1 |
 |
Karl
Cat-man,
The spec states: "Oil pressure, hot engine, operating speed: 59.7 - 92.5 psi"
My take on this: Operating speed = 3,000+
My experience is that under these conditions you typic..... |
|
|
|
Volvo:40,41,42,43,44 Series -
|
TAMD 41P Turbo impellar question |
VIEW/REPLY |
|
|
5
|
Thu Nov 19 09 11:58 PM |
Nov 18 2009
03:37 PM |
|
Bmac
So the little crappy stud that screws into the air filter bracket rattled out and bounced around on the impeller vanes of the turbo. Luckily it didnt suck it in. The vanes are pretty bent up. I con..... |
|
|
|
|
5 Responses....
|
|
Nov 19 2009
12:01 AM |
#1 |
|
Jay Leonard
Try High Tech Turbo. Google them and you´ll find their web address. |
|
Nov 19 2009
01:40 AM |
#2 |
 |
Todd Barnes
Bmac,
Post the part number from your turbo and I can help you out with a compressor wheel
Regards, Todd |
|
Nov 19 2009
02:57 PM |
#3 |
|
Bmac
Thanks,
I got this from the Volvopenta store website. I need part # 27. Turbocharger, Components: 861260 |
|
|
|
Nov 19 2009
02:59 PM |
#4 |
|
Bmac
Todd,
let me know if you need anymore info. I was planning on just removing the "cold side" and removing the nut that holds the wheel on. The turbos only have 800hrs and i really dont ne..... |
|
Nov 19 2009
11:58 PM |
#5 |
|
Todd Barnes
Brett,
Compressor wheel is on its way. Any questions don´t hesitate to contact me.
Regards, Todd |
|
|
|
Volvo:40,41,42,43,44 Series -
|
Lazy Tach |
VIEW/REPLY |
|
|
4
|
Thu Nov 19 09 10:56 PM |
Nov 10 2009
02:39 PM |
|
Cat-man
Looking for suggestions where to start.
My starboard tach does not come on until I get it above 2500 rpms(port)
Then works fine even when I go below 2500 rpms. Is this a bad tach or a bad conne..... |
|
|
|
Nov 17 2009
12:24 AM |
#2 |
|
Cat-man
Guys
Thanks for the ideas. Found a broken wire to the alternator.
It was the brown wire to D post (tough to read)´
W terminal was fine. Repaired d and all is well.
Can you tell me which each let..... |
|
Nov 19 2009
09:46 PM |
#3 |
 |
Gordy88
Hello
The D terminal is the warning wire and also the exiter wire. When the ignition is on and engine not running, the D terminal is -12v (negative) and is the negative for the battery warning ligh..... |
|
Nov 19 2009
10:56 PM |
#4 |
|
Cat-man
Gordon
thanks -- the more info the better
cat-man |
|
|
|
Volvo:40,41,42,43,44 Series -
|
Aetna Digital tach problem TAMD41P |
VIEW/REPLY |
|
|
1
|
Thu Nov 19 09 7:23 PM |
Nov 19 2009
06:42 PM |
|
Bmac
So both the tachs on the boat I bought were not working when i got it so know i am trying to figure out why. I was told they both quit working a few weeks before i bought it and I verified that by se..... |
|
|
1 Response....
|
|
Nov 19 2009
07:23 PM |
#1 |
|
Ralph Salerno
I would check the spade fittings at the sending units. They have a tendency to become dislodged when working on the engines. The signal comes from the valve train on my TMD40s. |
|
|
|
Volvo:40,41,42,43,44 Series -
|
Original or adaptable parts on line |
VIEW/REPLY |
|
|
3
|
Mon Nov 16 09 4:23 PM |
Nov 13 2009
09:53 AM |
|
Pepetou
Hello. I am from France, and i have a trawler with 2 VOLVO TAMD41A.
Does somebody get some website able to sell me original or adaptable parts for my engines. i´m looking for gaskets, oil coolers, r..... |
|
|
|
|
3 Responses....
|
|
Nov 15 2009
09:16 PM |
#1 |
|
Ralph Salerno
I order my parts online from Marine Parts Express. |
|
Nov 16 2009
02:00 PM |
#2 |
|
Dick V
I know there is always an interest to go online but why not use someone local that can help with questions and info that might be of help to you in time of need. Just a thought. |
|
Nov 16 2009
04:23 PM |
#3 |
|
Ralph Salerno
I would if I could find a dedicated Volvo dealer who knows something about the product. In my area, the dealers carry a myriad of brands and due to the high cost, do not stock Volvo parts. Since I do ..... |
|
|
|
Volvo:40,41,42,43,44 Series -
|
Black Smoke/Turbocharger Failure |
VIEW/REPLY |
|
|
1
|
Thu Nov 12 09 2:43 AM |
Nov 12 2009
01:34 AM |
|
MexPat
I have a new 37 foot w/l sports fishing vessel built in Ensenada, Mex and have installed twin Volvos KAMD43P engines. My attachment describes in detail what I have been going thru but here´s a short s..... |
|
|
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
Walker Air Filters - 41A |
VIEW/REPLY |
|
|
4
|
Wed Nov 11 09 5:43 PM |
Nov 5 2009
01:50 PM |
|
Capt. Mike
So I finally broke down and ordered the new Walker air filters which are a direct replacement on the 41A. They fit perfectly in the plastic housings. Well made and should provide many hours of service..... |
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
Injector removal 41p |
VIEW/REPLY |
|
|
4
|
Tue Nov 10 09 2:37 PM |
Nov 1 2009
09:16 PM |
|
Cat-man
Can I get some help on removing an injector.
It leaks ocassionaly only. Not sure if is between the injector and sleeve or the sleeve and the block.
Basically I need injector removal for dummies. (..... |
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
KAMD44 Supercharger Noise |
VIEW/REPLY |
|
|
7
|
Tue Nov 10 09 1:50 PM |
Nov 1 2009
09:06 PM |
|
Craig Jump
Started my KAMD44 up today with the engien cover off, and notice a squealing sounds.. thought it was one of the idler pulleys, but noticed it stopped when the supercharger cut out..
Have read vario..... |
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
New Clue in my Overheat Mystery |
VIEW/REPLY |
|
|
10
|
Sun Nov 8 09 3:50 PM |
Oct 27 2009
03:00 PM |
|
Sandiegomike
I have a chronic intermittent low rpm overheat problem with my single AD41P with outdrive in my 26 ft Osprey. I have replaced the impeller, thermostats, flushed both raw and fresh water sides, remove..... |
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
Paper seal on salt water pump |
VIEW/REPLY |
|
|
5
|
Sat Nov 7 09 9:14 PM |
Nov 7 2009
08:31 AM |
|
Pepetou
Hello.
With my 2 tamd41A I run 200H each year. When I check my salt water pump impeller they are quite news. Each control, when i open the pump i have to change the paper seal. I am leaving France, ..... |
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
Timing setting |
VIEW/REPLY |
|
|
2
|
Sat Nov 7 09 4:45 PM |
Nov 7 2009
08:27 AM |
|
Pepetou
Hello . I have a 2 TAMD41A fresly rebuilt. One of them is running smooth, yhe other is noisy. I proceed for an oil analysis. They found a hight level of steel in the noisy engine. The surveyor suggest..... |
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
Tamd 40b Tach |
VIEW/REPLY |
|
|
2
|
Thu Nov 5 09 4:56 PM |
Nov 5 2009
02:28 AM |
|
Kevin
Hi what is the best replacement for tamd 40b tach thank |
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
Has anyone removed a leg?? |
VIEW/REPLY |
|
|
3
|
Tue Nov 3 09 5:15 PM |
Nov 2 2009
11:00 AM |
|
joel AQAD41
i want to remove my engines to overhaul them and complete a thorough service.. Im familiar with the workings of an engine but have not removed a leg before.. what should i expect and how might be the ..... |
|
|
|
|
|
Volvo:40,41,42,43,44 Series -
|
Lift pump, injection pump, and performance? |
VIEW/REPLY |
|
|
16
|
Tue Nov 3 09 4:32 PM |
Sep 11 2009
03:20 PM |
|
Craig Collar
Hi all,
I recently measured the fuel pressure at the filter head of my 41 to test the condition of the lift pump. I couldn´t point to a symptom that would suggest a problem with the lift pump -- th..... |
|
|
|
|
View ALL
